7. ON LINE MODE
EO18-33011
7.1 THRESHOLD SETTING
7- 2
(8)
Press and hold the [PAUSE] key until more than 1.5 labels (tags) have been advanced.
The media is advanced until the [PAUSE] key is released.
(Threshold setting for the selected sensor is completed by this operation.)
(9)
Press the [RESTART] key.
(10) The printer is in stand-by.
(11) Send an issue command from the PC to the printer.
NOTES:
1. If the
[PAUSE]
key is released within 3 seconds whilst in pause state, paper will not feed.
2. Failure to feed more than 1.5 labels may result in an incorrect threshold setting.
3. While the Print Head Block is raised, the
[PAUSE]
key does not work.
4. Errors such as paper end and cutter error are not detected during paper feed.
5. Selecting the Transmissive Sensor (for pre-printed labels) within software commands allows the
printer to detect the proper print start position correctly even when using pre-printed labels.
6. If the printer continued to print out of position after setting the threshold, adjust the Feed Gap
Sensor in the system mode. Reset the threshold again. Make sure that the Transmissive Sensor
(for pre-printed labels) is selected in the feed and issue commands.
21 /,1(
21 /,1(
3$86(
