6. SYSTEM MODE
EO18-33011
6.6 PRINTER PARAMETER FINE ADJUSTMENT
6-29
••••
Strip Position Fine Adjustment (Example)
NOTES: 1. In strip issue, the media feed should be stopped where 1 mm-long label remains
on the strip plate. If, however, the feed stop position is improper due to too long
gap length, etc., a fine adjustment should be performed.
2. The fine adjustment value equals to the sum of the fine adjustment values set by
the PC command and this parameter.
The maximum strip position fine adjustment value is
±
50.0mm. When the value
reached the maximum, the value remains unchanged even if the subsequent fine
adjustment is performed.
6.6.3 Back Feed Length Fine Adjustment
With this parameter you can fine adjust the Back Feed Length. When “<3>ADJUST SET”
appears, press the [PAUSE] key 3 times.
[FEED] key:
Pressing the [FEED] key one time causes a –0.5mm change, up to –9.5 mm.
[RESTAT] key:
Pressing the [RESTART] key one time causes a +0.5mm change, up to +9.5
mm.
After completing the fine adjustment, press the [PAUSE] key.
BACK ADJ. +0.0mm
[RESTART]
[FEED]
BACK ADJ.+9.5mm
BACK ADJ.+9.0mm
BACK ADJ.+0.0mm
BACK ADJ.-9.0mm
BACK ADJ.-9.5mm
Platen
Print Head
Label
Strip Plate
Backing
Paper
-3.0 mm
+3.0 mm
+0.0 mm
1mm
Backing Paper
Label
Strip Plate
