6. SYSTEM MODE
EO18-33011
6.8 SENSOR ADJUSTMENT
6-44
Press the [PAUSE] key so that the printer enters the Pause condition. Then, press and hold the
[RESTART] key until “<0>RESET” message appears on the display.
Press the [FEED] key 5 times. The printer is at the start of the Sensor Adjustment menu.
6.8.1 Sensor Status Display
When “<5>SENSOR ADJ.” appears, press the [PAUSE] key to display the following.
Pressing the [PAUSE] key again shows the following display:
Press the [PAUSE] key to show the current black mark sensor status.
6.8.2 Black Mark Sensor Adjustment
Follow the Black mark sensor adjustment procedure below.
(1)
Load a tag stock in the B-492 printer so that the Black Mark Sensor detects a print area (no
black mark).
(2)
Press and hold the [RESTART] or [FEED] key for more than 3 seconds.
(3)
Press the [PAUSE] key to show the Feed Gap Sensor status.
<0>RESET
<5>SENSOR ADJ.
[REFLECT] 2.8V*
When the adjustment is completed, “*” appears.
[S]20
°
C
Heat Sink Temperature Sensor Status
0 to 86°C
[H]20
°
C [A]22
°
C
Print Head Temperature Thermistor Status
0 to 86 °C
Environmental Temperature Thermistor Status
0 to 86 °C
[REFLECT] 3.8V
The status detected by the Black Mark Sensor
0.0V to 5.0V
