6. SYSTEM MODE
EO18-33011
6.8 SENSOR ADJUSTMENT
6-43
6.8 SENSOR ADJUSTMENT
!
Outline of the Sensor Adjustment
In the Sensor Adjustment mode, the status of the sensors and thermistors is displayed. Also you can
make a Threshold Setting for the Black Mark/Feed Gap Sensor.
The Sensor Adjustment menu contains the following:
NOTES:
1. Perform a sensor threshold setting after changing the media to a different type.
2. An error related to the print position may be caused by the improperly set sensor
threshold. In this case please perform a threshold setting in this mode. In case further
adjustment is required, refer to Section 6.6 Printer Parameter Fine Adjustment to make
the threshold fine adjustment.
3. When pressing the [FEED] and [RESTART] keys at the same time in the Sensor
Adjustment menu, the display returns to “<5>SENSOR ADJ.”.
4. The sensor status is checked every 200 msec. Therefore, the display may change
according to the status.
<5>SENSOR ADJ.
[H]28
°
C [A]28
°
C
Sensor Status Display
(Print Head/Environmental Thermistor)
[S]25
°
C
REFLECT 3.5V
[TRANS.] 2.4V
[PE LV.R] 4.8V
[PE LV.T] 2.3V
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
Sensor Status Display (Heat Sink Thermistor)
Black Mark Sensor Adjustment
Feed Gap Sensor Adjustment
Black Mark Sensor Adjustment (Paper End)
Feed Gap Sensor Adjustment (No Paper)
