TANDBERG D14049.04, Administrator'S Manual

Page: 36 / 296

36
D14049.07
March 2010
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Introduction
Overview and
status
System
configuration
VCS
configuration
Zones and
neighbors
Clustering and
peers
Call
processing
Bandwidth
control
Firewall
traversal
Appendices
Applications Maintenance
Status
Event Log
Event Description Level
Message Rejected
This could be for one of two reasons:
•
The VCS Authentication mode is set to On , and an endpoint has unsuccessfully attempted to send a message (such as a registration request) to
the VCS. This could be either because the endpoint has not supplied any authentication credentials, or because its credentials do not match those
expected by the VCS.
•
Clustering is enabled but bandwidth across the cluster has not been configured identically, and the VCS has received a message relating to an
unknown peer, link, pipe, subzone or zone.
1
Message Sent
An outgoing RAS message has been sent. 2
Message Sent
An outgoing RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has been sent. 3
Message Sent
(SIP) An outgoing message has been sent. 4
Operator Call Disconnect
An administrator has disconnected a call. 1
Outbound TLS Negotiation Error
The VCS is unable to communicate with another system over TLS. Refer to the event parameters for more information. 1
Policy Change
A policy file has been updated. 1
POST request failed
A HTTP POST request was submitted from an unauthorized session. 1
Provisioning
Diagnostic messages from the provisioning server. The
Detail
event parameter provides additional information. 1
Reboot Requested
A system reboot has been requested. Refer to the
Reason
event parameter for specific information. 1
Registration Accepted
A registration request has been accepted. 1
Registration Refresh Accepted
A request to refresh or keep a registration alive has been accepted. 3
Registration Refresh Rejected
A request to refresh a registration has been rejected. 1
Registration Refresh Requested
A request to refresh or keep a registration alive has been received. 3
Registration Rejected
A registration request has been rejected. The
Reason
and
Detail
event parameters provide more information about the nature of the rejection. 1
Registration Removed
A registration has been removed by the VCS. The
Reason
event parameter specifies the reason why the registration was removed. This is one of:
•
Authentication change
•
Conflicting zones
•
Operator forced removal
•
Operator forced removal (all registrations removed)
•
Registration superseded.
1
Registration Requested
A registration has been requested. 1
Relay Allocated
A TURN server relay has been allocated. 2
Relay Deleted
A TURN server relay has been deleted. 2