285
D14049.07
March 2010
Grey Headline
(continued)
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Introduction
Overview and
status
System
configuration
VCS
configuration
Zones and
neighbors
Clustering and
peers
Call
processing
Bandwidth
control
Firewall
traversal
Appendices
Applications
Maintenance
Warnings
Warnings list
Warning message
Resolution
Configuration warning: expected default link between the Traversal Subzone and the Default Zone is missing
Configure
default links
Configuration warning: H.323 and SIP modes are set to Off; one or both of them should be enabled
Configure
H.323
and/or
SIP
modes
Configuration conflict: H323-SIP Protocol Interworking mode is set to "Registered only" but the H323-SIP Interworking Gateway option key has
been deleted
Reconfigure
Interworking mode
or reinstall the
option
key
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have an IPv4 gateway defined
Configure
IP settings
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have an IPv6 gateway defined
Configure
IP settings
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have any IPv4 addresses defined
Configure
IP settings
Configuration warning: IP protocol is set to both IPv4 and IPv6, but the VCS does not have any IPv6 addresses defined
Configure
IP settings
CRL checking required: your login account LDAP server configuration is recommended to have certificate revocation list (CRL) checking set to "All"
when in advanced account security mode
Configure
login account LDAP server
Encryption required: your login account LDAP server configuration is recommended to have encryption set to "TLS" when in advanced account
security mode
Configure
login account LDAP server
HTTPS client certificate checking: client certificate checking mode has changed, however a restart is required for this to take effect
Restart the VCS
HTTPS client certificate validation: you are recommended to enable client side certificate validation for HTTPS connections when in advanced
account security mode
Configure
HTTPS client certificate validation
Invalid clustering configuration: H.323 mode must be turned On - clustering uses H.323 communications between peers
Configure
H.323 mode
LDAP Configuration required: a valid Server Address, Server Port, BindDN and BaseDN are required if remote login authentication is used for
administrator or FindMe users
Configure
LDAP parameters
NTP server problem: the VCS is unable to determine the correct time and date
Check the
time
configuration
Port conflict: one or more ports have been configured for use by more than one service
Review the
port
configuration
Restart required: Ethernet configuration has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: HTTP service has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: HTTPS service has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: IP configuration has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: port configuration has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: QoS settings have been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: SNMP service has been changed, however a restart is required for this to take effect
Restart the VCS
Restart required: SSH service has been changed, however a restart is required for this to take effect
Restart the VCS