2.5.17 SI Channel Parameters Setting
Set the parameters of the SI channel.
a). Press the “MENU” button to view the channel state.
If a channel hasn't been fed with language output
temporarily, the LED displays “Not Engaged”, and if
the microphone of the Interpreter unit in the booth is
active, the audio parameters of the Interpreter unit
will be displayed on the LED and can be adjusted;
b). Press “MENU” button to select the channel number or
parameter and press “
/
” button to change the
channel number or parameter.
2.5.18 Headphone Mute Speaker
Set the work mode between loudspeaker and
headphone.
a)
Press the “
/
” button to select “Yes” or “No”;
If “Yes” is selected, the loudspeaker is muted
when the headphone is plugged;
If “No” is selected, the loudspeaker and the
headphone can work at the same time, the
loudspeaker sends out the floor channel only and
the headphone sends out the floor channel and SI
channels;
b) Press the “MENU” button to save and return to the
upper level menu.
2.5.19 Alarm Setting
Enable/disable alarm function.
a) Press the “
/
” button to select “Yes” or “No”;
b) Press the “MENU” button to save and return to the
upper level menu.
2.5.20 Parameters Backup/Restore
The system parameters can be backed up or restored
through the front panel USB port. Make sure that the USB
disk is properly connected, otherwise it will prompt “Please
insert the USB disk.”
a). Press the “
/
” button to select “Backup” or
“Restore”;
If “Backup” is selected, system parameters can be
backed up;
If “Restore” is selected, system parameters can be
restored;
b). Press the “MENU” button to confirm and to go to
selected menu item;
c). Return to the upper level menu after backup or restart
the main unit after recovery to save the parameters.
2.5.21 Voice Mode Setting
“Voice Mode Setting” includes two submenus:
“Voice Sensitivity”
“Auto Off Time”
“Voice Sensitivity”
a). Press the “
/
” button to select “Voice Sensitivity”
and press the “MENU” button to enter the setup
interface. Press the “
/
” button to select the “High”,
“Middle” or “Low”, shown as in the following figure:
Note:
The loudspeaker will be muted when plugging
all the two headphones of HCS-5301/80 or
HCS-4338NDDS/50 even if selected “No”.
Note:
If a HCS-8300MI is connected to the system and
is working in SI mode, the LCD displays “SI Ch
Engaged by 8300MI”.
29
Summary of Contents for HCS-5300MA/80
