Tadano ATF 130G-5, Translation Of The Original Operating Manual

Page: 151 / 636

Code Description Cause / remedy
E2136 Locking and unlocking sensors for B-pin
on one side or both sides are set to "ON".
Error in the B-pin locked/unlocked sensor.
Cable fault.
Internal AML error.
E2137 Locking and unlocking sensors for the C-
pin on one side are set to "OFF".
Note: The automatic mode is continued at
reduced speed with the help of the tele‐
scope cylinder length and the error-free
pins.
Error in the C-pin locked/unlocked sensor.
Cable fault.
Internal AML error.
E2138 Locking and unlocking sensors for C-pin
on one side or both sides are set to "ON".
Error in the C-pin locked/unlocked sensor.
Cable fault.
Internal AML error.
E2141 When the AML is activated or if emergen‐
cy operation no longer applies, the "Hoist‐
ing winch 1 up" button on the remote con‐
trol is not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2142 When the AML is activated or if emergen‐
cy operation no longer applies, the "Hoist‐
ing winch 1 down" button on the remote
control is not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2143 When the AML is activated or if emergen‐
cy operation no longer applies, the "Raise
HTLJ" button on the remote control is not
in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2144 When the AML is activated or if emergen‐
cy operation no longer applies, the "Lower
the HTLJ" button on the remote control is
not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2151 When the AML is activated or if emergen‐
cy operation no longer applies, a "Coun‐
terweight" button on the remote control is
not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2152 When the AML is activated or if emergen‐
cy operation no longer applies, the "Hoist‐
ing winch 2 up" button on the remote con‐
trol is not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2153 When the AML is activated or if emergen‐
cy operation no longer applies, the "Hoist‐
ing winch 2 down" button on the remote
control is not in a neutral position.
Switch button to neutral position. Button
error.
Short circuit of line.
Circuit board error.
E2154 When the AML is activated or if emergen‐
cy operation no longer applies, a "Boom-
Dismantling" button on the remote control
is not in a neutral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
E2157 When the AML is activated or if emergen‐
cy operation no longer applies, the "Set
Up Power System" button is not in a neu‐
tral position.
Switch button to neutral position.
Button error.
Short circuit of line.
Circuit board error.
3 Operation
ATF 130G-5 2146097
2014-09
151