Tadano ATF 130G-5, Translation Of The Original Operating Manual

Page: 153 / 636

Code Description Cause / remedy
E2195 Error in the angle sensor of the head sec‐
tion of the HLJ tip.
Input value of the sensor is outside the
normal range.
The normal range is 0.25-4.75 V
Sensor error.
Sensor cable broken or short-circuit.
Circuit board error.
E2196 Error in the angle sensor of the head sec‐
tion of the HTLJ tip.
Input value of the sensor is outside the
normal range.
The normal range is 0.25-4.75 V
Sensor error.
Sensor cable broken or short-circuit.
Circuit board error.
E2198 Error in the dynamometer of the Power
System.
The input value of the sensor is outside
the normal range.
The normal range is 0.25-4.75 V.
Sensor error.
Sensor cable broken or short-circuit.
Internal transmitter error.
E2201 Error in the diagnosis of output DO 1.
Error in diagnosis between target state
and actual state.
The output setting is ON, although it is set
by the AML to OFF.
Note: A crane movement is not possible.
Short circuit of signal line.
Circuit board error.
E2202 Error in the diagnosis of output DO 2.
Error in diagnosis between target state
and actual state.
The output setting is ON, although it is set
by the AML to OFF.
Note: A crane movement is not possible.
Short circuit of signal line.
Circuit board error.
E2209 Error in the diagnosis of output DO 1.
Error in diagnosis between target state
and actual state.
The output setting is OFF, although it is
set by the AML to ON.
Loose signal line.
Circuit board error.
Fuse blown.
Power line for AML relay interrupted.
E2210 Error in the diagnosis of output DO 2.
Error in diagnosis between target state
and actual state.
The output setting is OFF, although it is
set by the AML to ON.
Loose signal line.
Circuit board error.
Fuse blown.
Power line for AML relay interrupted.
3 Operation
ATF 130G-5 2146097
2014-09
153