Tadano ATF 130G-5, Translation Of The Original Operating Manual

Page: 135 / 636

Code Description Remedy
W0231 The remote control is activated.
Operation with crane control levers is not
possible.
—
W0246 Excessive tension in the rope of the Pow‐
er System.
When a load is slung, for safety reasons
the following functions must not be per‐
formed:
▪ Pretensioning the telescopic
boom.
▪ Release the pretension of the
telescopic boom.
Decrease the load.
W0247 Operation of Power System and HTLJ.
The following functions may only be car‐
ried out when the HTLJ is fully retracted:
▪ Telescope the telescopic boom.
▪ Pretensioning the telescopic
boom.
▪ Release the pretension of the
telescopic boom.
Fully retract the HTLJ.
W0248 Power System: Contaminated oil filter. Check oil filter, check oil.
W0255 The smallest offset angle of the hydrauli‐
cally adjustable jib has been reached.
For safety reasons, the offset angle of the
jib is limited:
▪ Stability at rear.
▪ Risk of hook block colliding with
the telescopic boom.
Lower the jib or the telescopic boom.
W0256 The hydraulically adjustable jib is located
outside the defined offset angle (smallest
angle undercut).
For safety reasons, the offset angle of the
jib is limited:
▪ Stability at rear.
▪ Risk of hook block colliding with
the telescopic boom.
Lower the jib or the telescopic boom.
W0263 The smallest offset angle of the jib LJ has
been reached.
Lower the jib or raise the telescopic boom.
W0264 The largest offset angle of the jib LJ has
been reached.
Raise the jib or lower the telescopic boom.
W0265 Setup mode for jib LJ: The largest offset
angle of the jib LJ has been reached
(80°).
Raise the jib or lower the telescopic boom.
W0266 Setup mode for jib LJ: The smallest angle
of the lower luffing mast is reached.
Lower the jib or raise the telescopic boom.
W0267 LJ jib: Minimum stroke of the fallback cyl‐
inder is reached.
Lower the jib or raise the telescopic boom.
3 Operation
ATF 130G-5 2146097
2014-09
135