2
1
Large Oscillating Saw Attachment (532.026),
17,000 osc./min
The Large Oscillating Saw Attachment is designed for
performing a crescentic saw cut (Fig. 1).
Inserting the Saw Blade
Insert the saw blade in the saw blade coupling (1) and
tighten the screw in the saw blade with the key (532.027)
that was delivered with the attachment (Fig. 2) or use a
T15 StarDrive screwdriver (e.g. 314.115).
Check that the saw blade is correctly in place and
properly tightened.
Mounting the Saw Attachment
Make sure that the locking sleeve (2) on the saw attach-
ment is set to the unlock position
(Fig. 3). Insert the saw
attachment in any position into the attachment coupling
of the handpiece until it locks into place. To prevent
vibrations during operation and to increase the sawing
capacity, additional manual tightening of the attachment
onto the handpiece is required. To achieve this, turn the
locking sleeve (2) into the lock position until you feel that
the coupling pins engage into the handpiece (approx.
half a revolution).
▲ Precaution:
Avoid applying high pressure onto the saw blade.
Removing the Saw Attachment
Turn the locking sleeve (2) to the unlock position
and
then push both release buttons on the handpiece.
Attachments
Saw Attachments
Figure 1
Figure 2
Figure 3
24
Instruction for Use • UNIUM
™
