Mini Quick Coupling (532.011)
J-Latch Coupling (532.012)
AO/ASIF Quick Coupling Drill Attachment, 1,255 rpm
Inserting and Removing the Cutting Tools
To connect the cutting tool, insert it into the attachment
by applying a light pressure while rotating it slightly until it
locks in place.
To disconnect, pull the coupling sleeve back and remove
the cutting tool.
■ Note:
Adapters (310.930, 310.93K*, 338.490, 338.49*, 511.300
and 511.30* and 532.031) can be used in connection with
the AO/ASIF Quick Coupling (05.001.250).
Drill Chuck Attachments, 1,255 rpm
Inserting and Removing the Cutting Tools
Open the jaws of the chuck using the appropriate key
or by hand. Insert the shaft of the cutting tool into the
open drill chuck and close it by twisting the chuck.
Make sure that the shaft lies central to the three jaws.
Tighten the drill chuck with the key. Make sure that the
teeth of the key engage correctly in the toothed rim of
the chuck.
To remove the cutting tool open the chuck with the key.
▲ WARNINGS:
•
To ensure secure insertion of the cutting tool, make
sure the toothed rims on the chuck and
key are not worn. Replace damaged or worn
components. Only use an original key.
•
Remove the original key from the drill chuck before
operating the handpiece.
Attachments for UNIUM™ Modular Handpiece
Drill Attachments
AO/ASIF Quick Coupling (05.001.250)
for cutting tools with an AO/ASIF coupling shaft.
Chuck, clamping range up to
B
4.0 mm
(05.001.252)
Chuck, clamping range up to
B
7.3 mm
(05.001.253).
Key (310.932)
Key (510.191)
Mini Quick and J-Latch Quick Couplings
Drill Attachments, 3,400 rpm
Inserting and Removing the Cutting Tools
To connect the cutting tool, pull the coupling sleeve
back and then insert the cutting tool while rotating slightly
until it locks in place.
To disconnect, pull the coupling sleeve back and remove
the cutting tool.
* available in USA only
18
Instruction for Use • UNIUM
™
