7
1
2
6
7
4
UNIUM™ Reciprocating Saw
Handpiece (05.001.611)
1 Mode Switch ON (reciprocating mode),
OFF (lock mode)
2 Trigger
3 Release Knob for Reciprocating Saw Blade
4 Release Buttons for Top of Sternum
5 Insertion Point for Top of Sternum
6 Casing Opening Button on the Front Lid
7 Casing Cover with Battery Level Indicator
To operate the handpiece, turn the Mode
Switch (1) to the ON position and press and
release the Trigger (2) to gradually increase and
decrease the reciprocating frequency, respectively.
▲ Precaution:
Insert a reciprocating saw blade into the coupling and
push until it locks in place. Gently pull on the saw blade to
ensure it is properly seated.
If using the Top for Sternum, mount it into the correct
position on the handpiece until it clicks (5). The tip of the
reciprocating saw blade (511.910S or 511.915S) must be
inside the slot of the guard.
The Top for Sternum can be mounted in 4 different
positions to accommodate the chosen surgical technique.
To release the Top for Sternum, press both release
buttons (4) simultaneously. Turn the Release Knob (3) in
the direction of the arrow to eject the reciprocating saw
blade.
Intraoperative Battery Level Check for Modular and
Reciprocating Saw Handpieces
The battery level can be checked intraoperatively by
pressing the trigger on the handpiece while the mode
switch is in the ON position or FWD ONLY position (for
the Modular Handpiece). The remaining capacity level is
visible on the Battery Level Indicator (7) on the bottom of
the handpiece.
■ Notes:
•
Turn the Mode Switch (1) to OFF, wait approximately
2 seconds, and then turn it back to either ON or FWD
ONLY before checking the battery level indicator (7) on
the casing cover.
•
The UNIUM Handpiece is automatically switched off
after two hours of inactivity. To reactivate it, switch it
OFF and ON again with the mode switch.
3
Reciprocating Saw Handpiece
UNIUM Handpieces
5
12
Instruction for Use • UNIUM
™
