DTC B1071 – Internal SDM Fault
DTC WILL SET WHEN
An internal SDM fault is detected by SDM.
DTC B1072 – Internal Side Sensor (Driver Side) Fault
DTC B1074 – Internal Side Sensor (Passenger Side) Fault
DTC WILL SET WHEN
DTC B1072 or B1074 :
SDM receive internal fault signal from side sensor.
CAUTION:
Be sure to perform Air Bag Diagnostic System Check before starting diagnosis according to flow
table.
NOTE:
DTC B1071 can never be cleared once it has been set.
1) Ignition switch OFF.
2) Replace SDM.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK.
CAUTION:
Be sure to perform Air Bag Diagnostic System Check before starting diagnosis according to flow
table.
1) Ignition switch OFF.
2) Replace side sensor.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK.
Summary of Contents for Wagon R RB310
