Suzuki Wagon R RB310, Supplementary Service Manual

Page: 185 / 254

10B-32 AIR BAG SYSTEM
Special tool
(A) : 09932-76010
(B) : 09932-75010
(C) : 09932-78310
2 1) With ignition switch OFF, disconnect Special
Tools (B) and (C) from “G65” connector.
2) Disconnect SDM connector “G66” from
SDM.
3) Release shorting bar in SDM connector
inserting release tool (1) included in special
tool (A).
4) Measure voltage from “G66-27” terminal to
body ground and from “G66-26” terminal to
body ground.
With ignition switch ON, are they 0 – 1V?
Substitute a known-good
SDM and recheck. Repair short from “GRN/
RED” or “GRN” wire cir-
cuit to power circuit.
3 1) With ignition switch OFF, disconnect Special
Tools (B) and (C) from “G65” connector,
then reconnect contact coil connector “G65”
as it was.
2) Remove driver air bag (inflator) module from
steering wheel (Refer to DRIVER AIR BAG
(INFLATOR) MODULE in Section 3C).
3) Check proper connection to driver air bag
(inflator) module at terminals in “Q08” con-
nector.
4) If OK, then connect Special Tools (B) and
(C) to “Q08” connector.
With ignition switch ON, is DTC B1025 current?
Ignition switch OFF.
Replace contact coil
assembly (Refer to COM-
BINATION SWITCH/
CONTACT COIL AND
COMBINATION SWITCH
ASSEMBLY in Section 3). Ignition switch OFF.
Replace driver air bag
(inflator) module (Refer to
DRIVER AIR BAG
(INFLATOR) MODULE in
Section 3).
Step Action Yes No
[A] : Fig. for STEP 1 and 2 1. Release tool
[B] : Fig. for STEP 2 2. SDM connector “G66”
[C] : Fig. for STEP 3 3. Contact coil connector “G65”
(A)
“G66-26” “G66-27”
[B] [A] [C]
(A)
“GRN”
“GRN/RED”
(B)
(A)
(C)
2
1
“Q08”
3
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.