Suzuki Wagon R RB310, Supplementary Service Manual

Page: 34 / 254

ANTILOCK BRAKE SYSTEM (ABS) 5E-17
Diagnostic Trouble Code (DTC) Check (Using
SUZUKI Scan Tool)
1) After setting cartridge for ABS to SUZUKI scan tool, connect
SUZUKI scan tool to data link connector.
Special tool
(A) : SUZUKI scan tool
2) Turn ignition switch ON.
3) Read DTC according to instructions displayed on SUZUKI
scan tool and print it or write it down. Refer to SUZUKI scan
tool operator’s manual for further details.
4) After completing the check, turn ignition switch off and dis-
connect SUZUKI scan tool from DLC.
Diagnostic Trouble Code (DTC) Clearance
After repair or replace malfunction part(s), clear all DTCs by per-
forming the following procedure.
1) Connect SUZUKI scan tool to data link connector in the
same manner as when making this connection for DTC
check.
2) Turn ignition switch ON.
3) Erase DTC according to instructions displayed on scan tool.
Refer to scan tool operator’s manual for further details.
4) After completing the clearance, turn ignition switch off and
disconnect scan tool from data link connector.
NOTE:
If SUZUKI scan tool cannot display DTC, perform
“SERIAL DATA LINK CIRCUIT CHECK” described in this
section.
WARNING:
When performing a driving test, select a safe place where
there is neither any traffic nor any traffic accident possi-
bility and be very careful during testing to avoid occur-
rence of an accident.