Suzuki Wagon R RB310, Supplementary Service Manual

Page: 10 / 254

GENERAL INFORMATION 0A-5
CAUTION:
• Even when the accident was light enough not to cause air bags to activate, be sure to inspect sys-
tem parts and other related parts according to instructions under “REPAIRS AND INSPECTIONS
REQUIRED AFTER AN ACCIDENT” in Section 10B as well as when air bag is deployment.
• When servicing parts other than air bag system, if shocks may be applied to air bag system compo-
nent parts, remove those parts beforehand.
• When handling the air bag (inflator) modules (driver, passenger and side), seat belt pretensioners
(driver and passenger), side sensors or SDM, be careful not to drop it or apply an impact to it. If an
excessive impact was applied, never attempt disassembly or repair but replace it with a new one.
• When grease, cleaning agent, oil, water, etc. has got onto air bag (inflator) modules (driver, passen-
ger and side) or seat belt pretensioners (drive and passenger), wipe off immediately with a dry
cloth.
• Air bag wire harness is included in instrument panel wire harness. Air bag wire harness branched
off from instrument panel wire harness can be identified easily as it is covered with a yellow protec-
tion tube and it has yellow connectors. Be very careful when handling it.
• When an open in air bag wire harness, damaged wire harness, connector or terminal is found,
replace wire harness, connectors and terminals as an assembly.
• Do not apply power to the air bag system unless all components are connected or a diagnostic
chart requests it, as this will set a diagnostic trouble code.
• Never use air bag system component parts from another vehicle.
• When using electric welding, be sure to disconnect all air bag (inflator) module connectors and pre-
tensioner connectors from air bag wire harness respectively.
• Never expose air bag system component parts directly to hot air (drying or baking the vehicle after
painting) or flames.
• WARNING/CAUTION labels are attached on each part of air bag system components. Be sure to fol-
low the instructions.
• After vehicle is completely repaired, perform “AIR BAG DIAGNOSTIC SYSTEM CHECK” in Section
10B.