Suzuki Wagon R RB310, Supplementary Service Manual

Page: 143 / 254

8D-6 WINDOWS, MIRRORS, SECURITY AND LOCKS
Keyless Entry System
(If Equipped)
Keyless entry system operation inspection
1) Confirm that power door lock system is good condition.
2) Confirm that all doors are closed and unlocked.
3) Check the following operation:
a) When pushing “LOCK” button (1) on transmitter (2) once,
check all doors lock and hazard waning lights flash once.
b) When pushing “UNLOCK” button (3) on transmitter (2)
twice, check all doors unlock and hazard waning lights flash
twice and interior light turn on several seconds with the
interior light switch in the middle position.
c) For vehicle equipped dead lock system:
When pushing “LOCK” button (1) on transmitter (2) twice
within 2 seconds, check all doors lock and not pulled up all
door lock knobs by hand.
If check result is not satisfied, go to “Keyless Entry System Circuit
Inspection” in this section.
Keyless entry system circuit inspection
Check that the voltage between the following terminals and body
ground are specifications under each conditions.
If check result is not as specified, check applicable circuit.
If circuit is normal, recheck keyless entry system circuit as follows.
1) Substitute a known-good door lock controller.
2) Register key code referring to “Code Registration Procedure”
in this section.
3) Recheck keyless entry system circuit.
2
1
3
1. Door lock controller
9 10 11 12 13 14 15 16 17 18
1 2 3 4 5 6 7 8
V
1