Suzuki Wagon R RB310, Supplementary Service Manual

Page: 195 / 254

10B-42 AIR BAG SYSTEM
Special tool
(A) : 09932-76010
(B) : 09932-75010
(C) : 09932-78310
2 1) With ignition switch OFF, disconnect Spe-
cial Tools (A) and (B) and (C) from “G67”
or “G72” connector.
2) Disconnect SDM connector “G66” from
SDM respectively.
3) Release shorting bar in SDM connector
inserting release tool (1) included in spe-
cial tool (A).
4) Measure voltage.
• DTC B1044 : between “G66-33” terminal
and body ground, and between “G66-34”
terminal and body ground.
• DTC B1048 : between “G66-36” terminal
and body ground, and between “G66-35”
terminal and body ground.
With ignition switch ON, is voltage 0 – 1 V?
Substitute a known-
good SDM and recheck. DTC B1044 :
Repair short “PNK” or “WHT”
wire circuit to power circuit.
DTC B1048 :
Repair short from “BRN” or
“LT GRN” wire circuit to
power circuit.
[A] : Fig. for STEP 1 and 2
[B] : Fig. for STEP 2
[C] : For DTC B1044
[D] : For DTC B1048
1. Release tool
2. SDM connector “G66”
Step Action Yes No
[C] [D]
[A] [B]
“G67”, “G72”
(A)
(B)
(C)
STEERING WHEEL
(A)
“G66-33” “G66-34”
(A)
“G66-35” “G66-36”
(A)
(A)
2 1
2
1
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.