Suzuki Wagon R RB310, Supplementary Service Manual

Page: 38 / 254

ANTILOCK BRAKE SYSTEM (ABS) 5E-21
DTC C1013 – Incorrect ABS Control Module Installed
DESCRIPTION
When abnormal signal is inputted to a no-used terminal of control module while running or incorrect ABS
hydraulic unit/control module assembly is installed, this DTC will be set.
INSPECTION
1) Ignition switch OFF.
2) Check for proper connection from harness to control module.
3) If OK, substitute an ABS hydraulic unit/control module assembly with correct part number.
4) Recheck system.
DTC C1015 – G Sensor Circuit
DESCRIPTION
While a vehicle is at stop or running, if the potential difference between the sensor signal terminal “E20-11” and
the sensor ground terminal “E20-13” is not within the specified voltage value, or if the signal voltage while at a
stop does not vary from that while running, this DTC is set.
Therefore, this DTC may be set when a vehicle is lifted up and its wheel(s) is turned. In such case, clear the
DTC and check again.
NOTE:
When ABS hydraulic unit/control module assembly for 2WD vehicle is installed to 4WD vehicle, this
DTC is set. Before preforming the INSPECTION as shown below, check part number for supply of ABS
hydraulic unit/control module assembly referring to parts catalogue.
1. Ignition switch 3. ABS hydraulic unit/control module assembly
2. G sensor 4. ABS hydraulic unit/control module connector
NOTE:
When ABS hydraulic unit/control module assembly for 4WD vehicle is installed to 2WD vehicle, this
DTC is set. Before preforming the INSPECTION as shown below, check part number for supply of ABS
hydraulic unit/control module assembly referring to parts catalogue.