Suzuki Wagon R RB310, Supplementary Service Manual

Page: 56 / 254

ANTILOCK BRAKE SYSTEM (ABS) 5E-39
INSTALLATION
1) Check that no foreign material is attached to sensor (1) and
ring.
2) Reverse removal procedure for installation noting the follow-
ing.
• There is another bolt hole (2) that is fit for wheel speed sen-
sor bolt by proper bolt hole (3).
Be sure to install wheel speed sensor and its bolt at the cor-
rect (upper) position as shown in figure.
Tightening torque
(a) : 10 N·m (1.0 kg-m, 7.2 lb-ft)
3) Check that there is no clearance between sensor and rear
axle shaft.
Rear Wheel Speed Sensor Ring (For 2WD
vehicle)
For removal, inspection and installation of rear wheel sensor ring,
refer to “BRAKE DRUM” in Section 5C.
Rear Wheel Speed Sensor Ring (For 4WD
vehicle)
INSPECTION
• Check rotor serration (teeth) for being missing damaged or
deformed.
• Turn wheel and check if rotor rotation is free from eccentricity
and looseness.
• Check that no foreign material is attached.
• If any faulty is found, repair or replace.
REMOVAL/INSTALLATION
For removal and installation of retainer ring of rear axle shaft,
refer to “REAR AXLE SHAFT AND WHEEL BEARING” in Section
3E.
CAUTION:
Do not pull or twist wire harness more than necessary
when installing rear wheel speed sensor.
NOTE:
The rear wheel speed sensor ring can not be removed or
replaced alone. If rear wheel speed sensor ring needs to
be replaced, replace it as a retainer ring of rear axle shaft.