Suzuki Wagon R RB310, Supplementary Service Manual

Page: 150 / 254

BODY SERVICE 9-1
9
8E
9
10
10A
10B
SECTION 9
BODY SERVICE
CONTENTS
Seats................................................................... 9-2
Front Seat ....................................................... 9-2
Rear Seat ........................................................ 9-4
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to “Air Bag System Components and Wiring Location View” under
“General Description” in air bag system section in order to confirm whether you are performing ser-
vice on or near the air bag system components or wiring. Please observe all WARNINGS and “Ser-
vice Precautions” under “On-Vehicle Service” in air bag system section before performing service
on or around the air bag system components or wiring. Failure to follow WARNINGS could result in
unintentional activation of the system or could render the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
“LOCK” position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
• When servicing vehicle body, if shock may be applied to air bag system component parts, remove
those parts beforehand. (Refer to Section 10B.)
NOTE:
• For the description (items) not found in this section, refer to the same section of the Service Manual
mentioned in FOREWORD of this manual.
• Fasteners are important attaching parts in that they could affect the performance of vital compo-
nents and systems, and/or could result in major repair expense. They must be replaced with one of
the same part number of with an equivalent part if replacement becomes necessary.
• Do not use a replacement part of lesser quality or substitute a design. Torque values must be used
as specified during reassembly to assure proper retention of these parts.