8) Route deployment harness (1) out of vehicle.
9) Verify that inside of vehicle and area surrounding vehicle are
clear of all people and loose or flammable objects.
10) Stretch deployment harness (1) to its full length 10 m (33 ft).
11) Place 12 volts vehicle battery (2) near shorted end of deploy-
ment harness (1).
12) Completely cover windshield area and front door window
openings with drop cloth, a blanket or any similar item (3).
This reduces possibility of injury due to possible fragmenta-
tion of vehicle’s glass or interior.
13) Notify all people in immediate area that you intend to deploy/
activate air bag (inflator) module or seat belt pretensioner.
14) Separate two banana plugs (1) on deployment harness (2).
15) Connect deployment harness (2) to 12 volts vehicle battery
(3). This will immediately deploy or activate air bag (inflator)
module or seat belt pretensioner.
16) Disconnect deployment harness (2) from 12 volts vehicle
battery (3) and short two deployment harness leads together
by fully seating one banana plug into the other.
1
2
3
NOTE:
• When air bag (inflator) module deploys or seat belt pre-
tensioner activates, rapid gas expansion will create
substantial report. Wear suitable ear protection. Notify
all people in immediate area that you intend to deploy
air bag (inflator) module or to activate seat belt preten-
sioner and suitable ear protection should be worn.
• After air bag (inflator) module has been deployed, sur-
face of air bag may contain powdery residue. This
powder consists primarily of cornstarch (used to lubri-
cate air bag (inflator) module as it inflates) and by-
products of chemical reaction.
WARNING:
• Do not place deployed air bag (inflator) module and
activated seat belt pretensioner near any flammable
objects.
• Do not apply water, oil, etc. to deployed air bag (infla-
tor) module and activated seat belt pretensioner.
• Wait for about 30 minutes before touching any metal
surface of air bag (inflater) module or seat belt preten-
sioner module. Disregarding these precautions may
cause fire or personal injury.
Failure to follow procedures may result in fire or personal
injury.
1
3
2
Summary of Contents for Wagon R RB310
