Suzuki Wagon R RB310, Supplementary Service Manual

Page: 237 / 254

10B-84 AIR BAG SYSTEM
1) Turn ignition switch to “LOCK” position and remove key.
2) Wear safety glasses during this deployment/activation proce-
dure.
3) Check that there is no open, short or damage in special tools
(deployment harness (A) and adapter cable (B)). If any faulty
is found, do not use it and be sure to use new deployment
harness.
Special tool
(A) : 09932-75030
(B) : 09932-78320
4) Short two deployment harness leads (2) together by fully
seating one banana plug into the other.
5) Remove air bag (inflator) module(s) or seat belt preten-
sioner(s) as follows.
• For driver air bag (inflator) module
Remove driver air bag (inflator) module from steering wheel
referring to “Driver Air Bag (inflator) Module” in Section 3C.
• For passenger air bag (inflator) module
Remove passenger air bag (inflator) module from instrument
panel referring to “Passenger Air Bag (inflator) Module” in
this section.
• For side air bag (inflator) module
Remove seat back (side air bag (inflator) module) from front
seat referring to “Front Seat and Rear Seat” in Section 9.
• For seat belt pretensioner
Remove seat belt pretensioner from vehicle referring to
“Front Seat Belt with Pretensioner” in Section 10.
NOTE:
If faulty of seat belt pretensioner connector (1) of adapter
cable (B) is found, replace it to spare connector (special
tool)
WARNING:
Deployment harness (A) shall remain shorted and not be
connected to 12 volts vehicle battery till you are ready to
deploy air bag module or activate seat belt pretensioner.