NVR Software - SeeTec Surveillance
86
5. Use the
Start test
and
Stop test
buttons to check your settings.
All amplitudes above the threshold line in the test field are recognized as motion.
6. To precisely set motion detection sensitivity, move this line up or down.
Important
The SeeTec motion detection feature can only be enabled and
configured if the camera delivers single frames, i.e. if the
Streaming mode
Motion JPEG
is selected in the
General
dialog
of the
Camera configuration
screen.
The motion detection feature only delivers suitable results for
motion detection in internal spaces.
For each active motion detection process, approx. 400 MHz of CPU
power are required on the SeeTec server.
Because the mapping of SeeTec motion detection to the video
stream is not unique when multi-streaming is enabled, the following
applies:
When multiple profiles use JPEG and are permanently active,
one of these is selected for motion detection.
If there is no additional profile, the basic profile is used,
provided it uses JPEG.
Motion detection of the server
Note
Use the motion detection of the server only if the camera does not
have integrated motion detection.
1. Activate the motion detection.
2. Optional: In the
Video analysis module
field, select the video analysis
module that is to be used for motion detection.
3. Only with multi-streaming enabled:
Select the profile in the
Profile
dropdown list.
4. In the
Areas
field, enter a name for the area that is to be created.
5. Click on the
+
button to create the area.
6. Click on the camera image to create a vertex for the area of the motion
detection.
7. With every further click, you create another vertex.
