InnoVet Select
™
HF APR
Service Manual
22
2.3.2 For Optional Float-Top Table
(Refer to figures on preceding pages for
reference.)
1.
Mount the tubestand bearing carriage to the tubestand using the four (4) 1/4
"
x 3/8" hex head screws provided. The picture on page 19 shows a
tubestand with a mounted bearing carriage.
Verify that the safety rollers
are mounted on the tubestand bottom to prevent the table from tipping
backwards from the weight of the tubestand
. (This may occur if the high
voltage transformer or control is not yet installed).
2.
To mount the tubestand, the table top frame will need to be moved forward
for access to the upper tubestand bearing rail at the left end of the table.
Refer to figures 5 and 6 for reference.
A)
Remove the single, large Phillips head screw found at the front and
rear interior corners of the tabletop frame.
B)
Now that the table top frame is free from the bearing tracks, raise the
frame slightly to gain access to the four small Phillips head screws
which secure the table top frame’s bearing track at the exterior head
end of the table. Remove these four screws, sliding the bearing track
forward. See figures 5 and 6.
C)
Manually release the transverse lock solenoid pins and slide the table
top frame forward to expose the upper tubestand bearing rail.
3.
Remove the tubestand stop on the left end of the table’s lower rear rail
(viewed from the front.) Position the tubestand so that it is a few inches from
the end of the back rail of the table with the lower tubestand bearings in line
with the back rail. See figures 2 and 3 for reference.
4.
Carefully tilt the tubestand away from the table until the lower tubestand
bearing can be pushed into the bearing rail. Now straighten the tubestand
and push it completely into the upper and lower bearing rails. See figure 4
on page 20 for reference. Reinstall the tubestand stop on the lower rail. A
well-leveled table will allow smooth motion of the tubestand with no drift in
either direction.
