Sulzer Metco ECO ARC 600, Manual

Page: 69 / 94

ECO ARC 600
7-1
Revision 1/10/08
7 Maintenance
Legend:
(D) daily
(W) weekly
(M) monthly
(A) annual
7.1 Spray device LD/U3
7.1.1 Control intervals
(W) Check contact nozzles for wear and centre alignment. Rub gra-
phite powder or contact grease on to the inside of the new con-
tact nozzles.
(W) Clean and wash out atomizer nozzle
(W) Clean or if necessary change gas nozzle.
(W) Clean radial air nozzle nut inside and outside. Spray with Teflon
spray.
(W) Clean fan spray nozzle inside and outside. Spray with Teflon
spray.
(M) Check wear of the wire feed rolls, if neccessary replace.
(M) Check smooth running of pressure rolls (bearing), if neccessary
replace.
(A) Grease worm gear in accordance with table of lubricants. To do
this the compressed air motor and worm shaft must be unscre-
wed, left-hand thread
(W) Each week flush the compressed air motor with an additional
10 drops approximately of air motor oil. To do this loosen the
hose connection on the compressed air motor and allow the oil
to drip directly into the motor