Stryker PneumoSure, Instructions For Use Manual

Page: 34 / 410

28
Using and Controlling the PNEUMO SURE High Flow Insufflator in High Flow Mode
EN
6.2 Selecting High Flow Insufflation Mode
1. Selection of the insufflation mode can be done only while insufflation is
stopped. If High Flow operating mode is not yet set and displayed, press the
function field
Change Mode for 2 seconds to get the insufflation mode over-
view.
2. The display depicts the different insufflation operating modes that can be ac-
tivated. Select the desired insufflation operating mode by pressing the High
Flow function field. *Inactive operating modes are displayed in gray.
3. The procedure profile is depicted on the display. The displayed parameters
correspond with the factory settings or the values set in the Configuration
menu (see chapter 10.1 Configuration menu I, page 60).
6.3 Presetting Nominal Pressure in High Flow Operating Mode
The nominal pressure can be set during insufflation or while insufflation is
stopped. Values may range from
1 to max. 30 mm Hg or the value set in the Con-
figuration menu.
Increasing/decreasing nominal pressure:
Briefly press the
º
or
»
function field to increase or decrease the pressure. Keep-
ing the
º
or
»
function field depressed longer than 1.5 seconds activates scrolling
in increments of 1.
Safety limit:
When increasing the nominal pressure, the status line of the display depicts Safe-
ty limit when reaching a value of 15 mm Hg . The nominal pressure 15 mm Hg is
a threshold value. This is where the recommended range for the intra-abdominal
pressure ends. Pressing the nominal pressure
º
function field again does not in-
crease the pressure any further. Release the function field for 2 seconds. Now you
can set a value up to 30 mm Hg.
CAUTION!
Exceeding this safety limit is to be decided by and the responsibility of the user/
operator.
6.4 Presetting Nominal Flow in High Flow Operating Mode
The nominal flow can be set during insufflation or while insufflation is stopped.
1. Briefly press the
º
or
»
function field to increase or decrease the flow. The
nominal flow can be increased from 1 to max. 40 l/min .
• Briefly press the corresponding field to set values in increments of 1.
(1)
(2)
START
Set Pressure
Actual Pressure
mm Hg mm Hg
Set Flow
l/min
Mode: High Flow
3 15
Change
Mode
Actual
l/min
0
Liter
0.0
0
GAS
START
Set Pressure
Actual Pressure
mm Hg mm Hg
Set Flow
l/min
Mode: High Flow
3 15
Change
Mode
Actual
l/min
0
Liter
0.0
0
GAS