Stryker Altrix 8001, Operation Manual

Page: 56 / 1068

E En ng glliis sh h
E EN N
1-48 8001-009-005 REV D www.stryker.com
Troubleshooting
Problem Possible cause Action Remove from use
Controller will not turn on
Power cord is not plugged
into a properly grounded
hospital grade wall outlet
Insert the plug fully into the
properly grounded hospital
grade wall outlet If the product does not turn
on after trying a different
outlet
Damaged power cord or
plug Visually make sure that the
power cord is not damaged If damaged, RFU
Controller user interface
blackout
Power outage
If the Stand-by button is
solid green, visually inspect
the LCD for damage If damaged, RFU
Product alarming, user
interface blackout Power outage If the Stand-by button is
yellow and flashing, visually
inspect the LCD for
damage If damaged, RFU
Temperature probe Not responding, does not
connect, temperature
outside of range Replace temperature probe
Check connections
If damaged, RFU
Controller will not heat
Reservoir is empty
Fill reservoir, tap Confirm
that water has been added,
restart If filling the reservoir does
not resolve
Controller will not cool Reservoir is empty Fill reservoir, tap Confirm
that water has been added,
restart If filling the reservoir does
not resolve
Thermal transfer device not
filling with water or ports
not detecting flow Locking ring on Clik-Tite
connector is not snapped
into place Check the Clik-Tite
connection
Replace the cable or
thermal transfer device
Thermal transfer device
may be to high, lower the
bed level
Thermal transfer device
may be folded, lay flat to
make sure the water flows
Not applicable
Quick disconnect not
seated properly Secure the thermal transfer
device connection to the
controller
Replace the cable or
thermal transfer device
Not applicable
Water level alarm Water level too low Fill reservoir Not applicable