Stratasys Eden350V, User Manual

Page: 124 / 182

Operating & Maintaining the Eden350V 3D Printer
6–18
DOC-03050 Rev. A
Maintaining the Printer
The performance of routine maintenance tasks is essential for getting
satisfactory results from Eden 3D printers. Perform the tasks at specified
intervals for optimum performance.
Routine
Maintenance
Schedule
Frequency Task For More Information
Before / after printing Check UV lamp
overheating indicator.
See “UV Lamp Check”
on page 21.
Before / after printing Clean the print heads
and the roller surface.
See “Cleaning the Print
Heads and the Roller”
on page 21.
Daily Clean and inspect the
wiper.
See “Cleaning and
Replacing the Wiper”
on page 24.
Weekly Clean the build tray and
the surrounding area.
Weekly Perform the Pattern test. See “Pattern Test” on
page 26.
Weekly— when printing
with MED610
Calibrate the UV
intensity.
See “Testing and
Calibrating the UV
Lamps” on page 49.
Weekly Restart the printer
computer and the
server computer.
Weekly Clean the roller waste
collector.
See “Cleaning the Roller
Waste Collector and
Inspecting the Roller
Scraper” on page 28.
Every 300 hours of
printing (A reminder
message appears.)
Calibrate the UV
intensity.
See “Testing and
Calibrating the UV
Lamps” on page 49.
Every 300 hours of
printing (A reminder
message appears.)
Optimize the print
heads.
See “Calibrating Print
Heads” on page 37.
Monthly, and after
replacing print heads
Check the alignment of
the print heads.
See “Aligning the Print
Heads” on page 33.
Monthly Inspect the exhaust
system (duct, fan,
connections).
Monthly Calibrate the load cells. See “Calibrating the
Load Cells” on page 56.
Every 3500 hours of
printing or every two
years
Preventive maintenance
visit by authorized
service engineer.
Contact your Stratasys
service provider.