ASTOFLO PLUS ECO Instructions for Use
9 Getting started
32
1. Prime the infusion line before or after inserting into the heating profile: Allow
fluid to flow until no air is observed in the infusion line and the line is primed
with fluid.
To facilitate insertion of the infusion line, the heating profile can be
dusted with usual in trade powder or talcum powder.
Fig. 8 Inserting infusion line
2. Start inserting the infusion line at the free end of the heating profile, about
3 cm to 5 cm behind the luer locks connection (Fig. 8 A) of the infusion set.
3. With the thumb, insert the infusion line into the groove heating profile (Fig. 8 B).
4. The best performance is achieved when as much as possible infusion line is
inserted in the heating profile. Roller clamps can protrude from the profile at
any point (Fig. 8 C).
Fig. 9 Fixing the heating profile
5. Fix the heating profile/infusion line in the desired length with the clip (Fig. 9 A).
The opening of the groove must be orientated to the front to allow a smooth
guidance of the infusion line without kinks.
