Stanley QB Expert, Instruction Manual

Page: 199 / 214

Instruction Manual
191
Maintenance
Message Possible Cause Probable Solution
Major Consideration
That Led to Solution
To Clear/Reset from
Message Condition
Tool Disabled
Continued
A input is applied
that is assigned as
STOP
Remove the active
input.
Reassign input.
Tool Disabled: Stop
Issued message on
display when the
operator pressed
the tool’s start
trigger
Remove the active
input.
Reassign input.
Job/ Task Verify
inputs not matching
selected Job/ Task.
Select a different
Job/Task.
Select a different
socket for
verification.
Tool Disabled: Stop
Issued
message on
display when the
operator pressed
the tool’s start
trigger
Select a different
Job/Task.
Select a different
socket for
verification.
The controller is
in the process of
booting
Wait until the
controller has
finished the boot
up process
Tool Disabled:
System
Initializing
message on display
when the operator
pressed the tool’s
start trigger
Wait until the
controller has
finished the boot
up process
The Cycle Lock-out
timer is active
Wait for the timer
to reset.
Change the Cycle
Lock-out timer
value.
Tool Disabled:
Cycle Lock-out
message on display
when the operator
pressed the tool’s
start trigger
Wait for the timer
to reset.
Change the Cycle
Lock-out timer
value.
Reject Count
Exceeded
Reset the Job
Tool Disabled:
Reject Count
Exceeded
message
on display when
the operator
pressed the tool’s
start trigger Reset the Job
Logic criteria
not met for tool
operation
Retrain operator on
proper process to
insure the internal
PLC logic is met
Tool Disabled:
Internal PLC
message on display
when the operator
pressed the tool’s
start trigger
Retrain operator on
proper process to
insure the internal
PLC logic is met.
Delete the PLC
program.