Stanley QB Expert, Instruction Manual

Page: 51 / 214

Programming
Instruction Manual
43
Task.
Add
Adds a Task to the controller. If a tool is attached, the Wizard begins for easy setup of
parameters. If a tool is not attached the Tasks tab appears for manual parameter setup.
Tasks do not have to be added sequentially. A Task can be added before or after the one
that is selected. Tasks renumber automatically after being added. Make a selection and
press OK to add a Task, or CANCEL to not add a Task
Delete Deletes the selected Task from the controller. Tasks cannot be recovered once deleted.
Copy
Copies the selected Task and its associated Steps to the Clipboard.
Paste
Overwrites the selected Task with the values residing in the Clipboard.
To copy/ move a Task: first create a new Task where it is needed, than copy the Task to be
moved, then paste into the new Task created and delete the original if required.
Press the EXIT interactive menu button to save changes and return to the Run screen. See section “3.1.2.6 Exit”
on page 52.
Press the BACK interactive menu button to return to the Job level.
3.1.2.4 Step Button
Press the STEP interactive menu button to setup the parameters of the Step(s) inside the selected Task.
Step settings only affect the selected Job and Task. There can be only one Audit step per Task. Each Step is