Standard SD462, Operator'S Manual

Page: 138 / 558

Printing Functions
122
3
Skip Feed
If the backs of prints are dirty, you
can use the Skip Feed function to
make the drum rotate twice instead of
once with every sheet of paper fed.
This gives you time to remove prints
one by one from the paper delivery
tray or to insert a sheet of paper be-
tween two prints.
Preparation
The number of rotations can be set
from 2 to 9. The default is 2. To
change this setting, see p.186 “Skip
Feed”.
Limitation
❒
When duplex printing, the ma-
chine cannot perform skip feed. If
skip feed has been set, cancel skip
feed by pressing the
{
Start
}
key to
begin duplex printing.
Note
❒
As the paper feeding time is longer
than usual, you can use paper
longer than the length limitation.
The maximum length of paper in
Skip Feed mode is 460 mm, 18.1".
Before use this function, you
change the default of longer paper
setting, see p.186 “Longer Paper”.
❒
When you use paper longer than
447 mm, 17.6", prints will not be
delivered to the paper delivery
tray properly, so lower the paper
delivery end plate and take out the
prints by hand.
A
Place the originals.
B
Press [ Skip Feed ] .
To change the number of drum
rotations
In this step, you can change the
number of rotations temporarily.
You can also have this step omitted
by adjusting the User Tools set-
tings. See p.186 “Skip Feed”.
A
Select the number of drum ro-
tations per sheet of paper fed
with number keys.
B
Press [ OK ] .
C
Press the
{
Start
}
key.