SSD 605C, Product Manual

Page: 61 / 236

The Operator Station
5-11
605C Frequency Inverter
Changing the Product Code
On rare occasions it may be necessary to change the default settings by changing the Product
Code. The Product Code is
referred to in Chapter 2. You can select a different Language field
(with associated frequency) and power rating for the Inverter; other information is automatically
read from the power board.
A special key combination is required to change the product code. This feature is only available
at power-up as a security measure.
•
Hold down the
∆
, E and PROG keys, then power-up the Inverter
An alert message may be displayed, “ALERT CONFIG MODE”. This is warning you that you
have initialised the Operator Station into the configuration mode and therefore parameters
can be changed.
•
Use the up (
∆
) and down (
∇
) keys to select a default setting
•
Hold down the E key to exit
The new settings will be saved automatically, and all defaults will be restored.
Note: Holding down the
∆
, E and PROG keys whilst displaying the Welcome screen will also
display the product code, but you will be unable to change the parameter. To go to the
Welcome screen, press the PROG key until you enter the Operator menu system, then
press the E key until the Welcome screen is displayed.
Quick Restore Default
A special key combination restores to the Inverter the current product code default values and
Macro 1 parameter values. This feature is only available at power-up as a security measure.
•
Hold down the up (
∆
) and down (
∇
) and keys, then power-up the Inverter.
Menu Viewing Levels
For ease of operation, there are three `viewing levels` for the Operator Station. The setting for
the viewing level decides how much of the menu system will be displayed.
The choice of menu for each has been designed around a type of user, hence we have the
Operator, Basic and Advanced viewing levels.
Note: The contents of the OPERATOR menu remains unchanged for all view levels.
Refer to “The Menu System Map”, page 5-5 to see how the viewing level changes the displayed
menu.
To change the viewing level, go to MENUS menu at level 1. The first parameter in this menu,
VIEW LEVEL, selects the viewing level.
Startup Screen Timeouts
Another action of selecting different viewing levels is to introduce a timeout to the Startup
screen. By default, the Startup screen is the SETPOINT parameter, but you can select any
parameter to be the Startup screen.
Operator viewing level
The Startup screen will be displayed after an extended period without a key press when
viewing the Welcome screen or the VIEW LEVEL parameter in the MENUS menu at
level 1.
Basic viewing level
There is no timeout
Advanced viewing level
There is no timeout