SSD 605C, Product Manual

Page: 102 / 236

6-36
Programming Your Application
605C Frequency Inverter
LOCAL CONTROL
This block allows the available modes of
Local and Remote operation to be
customised. It also indicates the selected
mode.
Switching between Local and Remote
modes can only be done using the Operator
Station. Refer to Chapter 5: “The Operator
Station” - The L/R Key.
MMI Menu Map
1 SETUP PARAMETERS
2 FUNCTION BLOCKS
3 SEQ & REF
4 LOCAL CONTROL
SEQ MODES
REF MODES
POWER UP MODE
SEQ DIRECTION
REMOTE SEQ
REMOTE REF
LOCAL CONTROL
REMOTE SEQ [297] – TRUE
REMOTE REF [257] – TRUE
LOCAL/REMOTE – [298] SEQ MODES –
LOCAL/REMOTE – [265] REF MODES –
REMOTE – [299] POWER UP MODE –
FALSE – [281] SEQ DIRECTION –
Parameter Descriptions
SEQ MODES Range: Enumerated - see below
Allows the source of sequencing commands to be selected. Local is the Operator Station,
Remote is an external signal. The modes supported are:
Enumerated Value : Seq Mode
0 : LOCAL/REMOTE
1 : LOCAL ONLY
2 : REMOTE ONLY
REF MODES
Range: Enumerated - see below
Allows the source of the reference signal to be selected. Local is the Operator Station, Remote is
an external signal. The modes supported are:
Enumerated Value : Ref Mode
0 : LOCAL/REMOTE
1 : LOCAL ONLY
2 : REMOTE ONLY
POWER UP MODE Range: Enumerated - see below
Allows the power-up operating mode of the Inverter to be selected. Local is the Operator
Station, Remote is an external signal, Automatic is the same mode as at power-down. The modes
supported are:
Enumerated Value : Power Up Mode
0 : LOCAL
1 : REMOTE
2 : AUTOMATIC
SEQ DIRECTION Range: FALSE / TRUE
When TRUE, direction is a Sequencing command.
When FALSE, direction is a Reference command.
REMOTE SEQ Range: FALSE / TRUE
This parameter indicates the present source of the sequencing commands.
REMOTE REF Range: FALSE / TRUE
This parameter indicates the present source of the reference signal.