Spirent SmartBits System, Reference Manual

Page: 109 / 278

Chapter 9: Ethernet Cards
LAN Series Modules
SmartBits System Reference 101
LAN-3111A Module
•
LAN-3111A SmartMetrics 6-port 100 Base-FX fiber full duplex module
Card Type:
SmartMetrics Ethernet 100 Base-FX Fiber.
Where Used:
SMB-600 and SMB-6000B.
Applications
Supported:
SmartWindow, SmartLib, SmartApplications, SmartFlow, SmartVoIPQoS, SmartTCP,
SmartxDSL, SmartCableModemTest, SmartMulticastIP, AST II.
Devices Tested:
Layer 2 and 3 devices and end-to-end systems.
Test Objective:
Designed for IEEE-compliant 100 Base-FX systems and supports VLAN tagging and flow
control to IEEE standards 802.3p, 802.3Q, 802.3ac, and 802.3x.
Features:
•
High port density.
•
Full wire-rate traffic generation and analysis.
•
Data integrity checking – allows verification of payload data through the DUT.
Testing:
Performs frame loss, stream latency, and sequence tracking tests on systems ranging from
a single device under test to a complex routed network featuring the following
SmartMetrics tests:
•
Sequence Tracking.
•
Latency over Time.
•
Latency per Stream.
•
Latency Distribution.
•
Raw Tags.
•
Frame Variation.
Specifications:
•
Interface:
– IEEE 802.3 serie3s 100 Base-FX specifications.
– 1300nm multi-mode fiber.
•
Connector type: LC-Fiber.
•
Line Rate: 100 Mbps, full-duplex only.
•
Port Density: 6 ports per LAN-3111A module.