Spike Systems PBG Series, System Manual

Page: 23 / 94

Spike Systems: PBG System Family Installation
15
Section 2 – Physical Installation
2.1 Installation Planning
Often when a Spike System is installed, another lower-­‐cost barrier gate is installed in front of the
Spike Systems unit. This is to protect against damage caused by low-­‐speed and inadvertent
actions by the driver. These lower cost gates are available from Spike systems. Typically, a
Magnetic Autocontrol MicroDrive MHTM is most commonly installed for this purpose. These
secondary gates can be installed before, during or after the installation of the Spike Systems
barrier. The MHTH is packaged separately and has a comprehensive installation manual that
should be referenced throughout the installation process. Detailed information on these
systems can be found on the Internet at:
https//magneticgateopeners.com/store/pdfs/microdrive-­‐manual.pdf
.
2.2 Installation Preparation: System Unpacking
All PBG systems are shipped to the installation site on custom designed pallets. An example is
shown below.
NOTE – Use a forklift or a sufficient number of laborers to lift the shipped pallets,
the Control Cabinet (shown on the left), and the Non-­‐Control Cabinet (shown on the right), the
Plate Barrier Gate assembly (not pictured). The use of safety gloves is advised whenever lifting
or handling PBG cabinets and components. Unbolt the Control and Non-­‐Control Cabinets from
the custom pallet using a 1/2“ wrench or ratcheting socket.
Figure 12 -- Control and Non-Control Cabinets Secured to Shipping Pallet
Tool Required Tool Type Tool Specification
½” Wrench/Socket To remove hardware
securing system
cabinets to pallets
Safety Gloves