Spike Systems PBG Series, System Manual, Page: 35 / 94

Spike Systems: PBG System Family Installation
27
Section 3 – Hydraulic, Electrical, and Control Installation
3.1 Hydraulic Hose Installation
The factory pre-­‐installs a set of hydraulic hoses to the Hydraulic Cylinder in the Control Cabinet.
The two hydraulic hoses that are coiled up in the Control Cabinet are threaded from the Control
Cabinet through the track to the Non-­‐Control Cabinet. Once routed through the track, the two
hoses are attached to the Hydraulic Cylinder in the Non-­‐Control Cabinet.
The two hoses that are to be threaded through the track are coiled up in the Control Cabinet as
shown below. Start this portion of the installation by uncoiling the hydraulic hoses and
extending them fully to ensure that there are no kinks or bends in the hoses.
Figure 25 – Hydraulic Hose Location, As Shipped, Inside Control Cabinet
To connect the hydraulic hoses to the Hydraulic Cylinder in the Non-­‐Control Cabinet, place the
hoses on the ground and carefully position the track over the hoses ensuring that the track does
not pinch or rest on any segment of hose.