![background image](http://html.mh-extra.com/html/sony/nas-z200dir/nas-z200dir_operating-instructions-manual_1330164076.webp)
NAS-Z200DiR/Z200iR.GB.4-151-738-
12
(1)
GB
8
Firmly secure the unit and the Base Plate using the 2 supplied screws (+PSW4 ×
12).
Secure the screws to the angle mark 0.
Screw (+PSW4 × 12)
Note
When using an electric screwdriver, set to torque setting to approximately 1.5N.m (15 kgf.cm).
WARNING
Be sure to tighten both left and right securing screws firmly. If you fail to do so, the unit may fall when it is pushed
upward and cause injury.
9
Confirm the completion of the installation.
Check the following points.
The hooks of the Mounting Hook are firmly latched in the holes of the Base Plate.
The power cord is not twisted or pinched.
The 2 screws that secure the Mounting Hook and the Base Plate are securely tightened.
WARNING
Do not adjust the angle of the Mounting Hook when the unit is installed on the wall and be sure that the
Mounting Hook is fully engaged. Otherwise it may cause the product to fall and result in injury and/or
product damage. Also, improper placement of the power cord, etc., may cause fire or electric shock
through a short circuit. Be sure to confirm the completion of the installation for safety.