![background image](http://html.mh-extra.com/html/sony/nas-z200dir/nas-z200dir_operating-instructions-manual_1330164064.webp)
NAS-Z200DiR/Z200iR.GB.4-151-738-
12
(1)
GB
2
Slide and remove the
battery compartment lid as
shown below.
Battery
compartment lid
3
Remove the two screws
from the metal sheet.
The battery is stored under the
metal sheet.
Metal sheet
4
Remove the metal sheet and
the built-in battery.
The battery is attached to the
metal sheet by adhesive tape.
Note
Be careful not to hurt yourself
when handling the metal sheet.
5
Disconnect the cable that
connects the battery to the
remote control.
About this unit
If you have connected to an
outside network, such as the
Internet, and have allowed access
from other devices, unauthorized
access by malicious outsiders can
occur depending on your network
configuration. It may cause
damages such as data falsification.
To avoid this problem, before
using this unit, you need to:
— Use a router and configure it
correctly.
— Register the equipment that is
to access this unit.
It is prohibited to send or leave
copyrighted products to/on an
out-of-home network which can
be accessed from many people
without the author’s permission by
the Copyright Act.
About DLNA support:
This product is designed
in accordance with DLNA
Guideline v1.0. This product is
commercialized to gain formal
DLNA accreditation. This product
may be upgraded to maintain
interconnectivity.
About the built-in battery in the
remote control
If the remote control loses its
charge:
A charged remote control will
gradually lose its charge when it
is not used for a long time. If it
does, it may not be able to turn on
the unit. If this happens, place the
remote control on its charger to
charge up the built-in battery. You
should charge the remote control
at least once every 6 to 12 months
even when not using the unit.
About the charging time and
operating time of the remote
control:
The amount of time it takes
to charge the remote control’s
built-in battery and the amount
of time until it must be charged
again depend on the surrounding
temperature. If possible, you
should avoid charging or
operating the remote control in
places subject to extremely high or
low temperatures.
About charging:
If you remove the remote control
from the charger before the
built-in battery is fully charged,
charging may not resume even if
you place the remote control on
the charger again. The operating
time of the remote control will
thus be shorter than it would
normally be. Wait until the
CHARGE indicator has turned off
to ensure that the remote control
is fully charged.
On the speaker system
This speaker system is not
magnetically shielded, and the
picture on nearby TV sets may
become magnetically distorted. In
this situation, turn off the TV, wait
15 to 30 minutes, and turn it back
on. If there is no improvement, move
the speakers far away from the TV.
Do not drop this unit
Do not subject the unit to strong
shocks. It may cause the unit to
malfunction.
Do not exert strong pressure on
the front side of this unit where
the speakers are mounted.
On volume adjustment
CDs reproduce sound with
considerably less noise than vinyl
records. For this reason, if you raise
the volume while listening to a
segment containing only noise (as
you might do in the case of a vinyl
record), a sudden output of high-
volume sound may cause damage to
the speakers.
Make sure to lower the volume
before the start of playback.