Sony DVCAM DSR-60, Service Manual, Page: 207 / 324

6-33 DSR-80/80P/60/60P
3. Place this unit with its left side down.
4. Remove the three screws (PWH 3 x 6) fixing the
bottom case to the MD chassis, and remove the
bottom case in the direction of arrow.
5. Remove the capstan motor.
(Refer to section 6-9.)
6. Remove the flexible card wire (CN11 on the
RM-159 board in the case of S side, or CN15 on
the RM-160 board in the case of T side) which is
connected to the reel block.
7. Remove the two flexible card wires (CN203,
CN206) which are connected to the MS-43
board.
8. Remove the three flexible card wires (CN201,
CN202, CN208) and three harnesses (CN210,
CN211, CN221) which are connected to the MS-
43 board.
9. Remove the connectors of the top sensor holder
and the end sensor holder from CN212 and
CN205 on the MS-43 board.
10. Remove the five screws (PWH 2.6 x 6) fixing the
MS-43 board to the MD chassis, and remove the
MS-43 board.
11. Remove soldering of the two diodes and two
photo transistors on the MS-43 board. Release
the four claws of the RS sensor holder. Remove
them altogether.
12. Remove the two diodes and two photo transistors
from the holders respectively. (Fig.-2)
Attachment
13. Insert the four claws of the RS sensor holders
into the holes of the MS-43 board.
14. Insert the new diodes and new photo transistors
into the holders respectively and solder them on
the MS-43 board.
15. Attach the disassembled parts by reversing the
removal procedure from steps 10 to 1.
PWH 3 x 6
Capstan motor
MS-43 board
Bottom case
MB shield
case assembly
T reel
S reel
CN11
CN15
RM-160 board
RM-159 board
Flexible card wire
Flexible card wire
PWH
2.6
x 6
PWH
2.6
x 6
PWH
2.6
x 6
PWH
2.6
x
6
PWH
2.6
x 6
Flexible card wire
Harness
Claw
Claw
RS sensor holder
Diode
Diode
Photo transistors
Fig.-2
MS-43 board CN212
CN211
CN202 CN203
CN208
CN210
CN206
CN211
CN205
CN201
MS-43 board