1-16
DNW-A220
DNW-A220P
DNW-A220 (S/Y) S/N 31001 through 31330
Joint plateA
Joint plate B
Joint plate
Joint plate A
Joint plate
Handle assembly
Coin screw
Coin screw
B3
x
8
B3
x
8
B3
x
8
B3
x
8
B3
x
8
B3 x 8
Screw
Screw
B3
x
8
B3
x
8
Joint plate B
Joint plate A
B3
x
8
B3
x
8
Screw
Joint plate B
51001 through 51330
DNW-A220 (SY) S/N 31331 and higher
DNW-A220P (SY) S/N 31717 and higher
51717 and higher
DNW-A220P (SY) S/N 31001 through 31716
51001 through 51716
DNW-A220 (S/Y) S/N 31001 through 31330
51001 through 51330
DNW-A220P (SY) S/N 31001 through 31716
51001 through 51716
DNW-A220 (SY) S/N 31331 and higher
DNW-A220P (SY) S/N 31717 and higher
51717 and higher
51331 and higher
51331 and higher
1-6. Removing/Installing the Cabinet
This section explains the removal and installation procedures for main parts.
For other mechanical parts, refer to the maintenance manual Part 2 Volume 1.
1-6-1. Separating/Coupling the Player and Recorder
Separating
1.
Disconnect all cables connected at the connector panels.
2.
Remove the handle assembly.
(1) Loosen two coin screws fully.
(2) Remove the handle assembly while sliding in the direction of the arrow.
3.
Remove the three screws securing each connection plate to separate.
Coupling
Couple the player and recorder in the reverse order of separation. Improper coupling may cause the risk
of personal injury during transport.
m
.....
When coupling, place the two VTRs in a horizontal position.
.....
The screws securing the connection plates should be torqued as specified.
Tightening torque:
1.4 N
.....
m (14 kgf
.....
cm)
1-6. Removing/Installing the Cabinet
