3-3
BKS-R3219A/R1617A I&SSM
Note) In IXS-6600/IXS-6700, “P/S switch on CPU board” means S1203-2 and 3 on the CA-65 board.
In HKSP-R80, it means S803-2 and 3 on the CPU-355 board. In HDS-X5800, it means S702-1, 2, 3, and 4 on the CPU-339 board.
3-1-2. Symbols Used in This Manual
The symbols used for the control terminal emulator keys in
this manual are as follows.
.
All keys are enclosed in boxes. (Ex.
[Ctrl]
,
[Enter]
)
.
The numerical keys in the text mean keys
[0]
to
[9]
.
.
The alphabet keys in the text mean keys
[A]
to
[Z]
.
.
The cursor key in the text mean the
[(]
,
[)]
,
[&]
, and
[*]
keys.
.
When two keys are to be pressed together, they are
joined by the “
_
”. (Ex.
[Ctrl]
_
[X]
)
.
In IXS-6600/IXS-6700, “P/S switch on CPU board”
means S1203-2 and 3 on the CA-65 board.
In HKSP-R80, it means S803-2 and 3 on the CPU-355
board. In HDS-X5800, it means S702-1, 2, 3, and 4 on
the CPU-339 board.
3-2. Preparation
1.
Setting the secondary station
Setting the station ID
(Refer to Section 2-11-2.)
Set the switch to the desired station ID in the range of
2 to 254 so that it is not duplicated with the station IDs
of other secondary equipment.
2.
Setting the primary station equipment
Set the P/S switch
Note)
on the CPU board of the
primary station equipment to the [P] position.
3.
Connecting the primary station equipment to the other
secondary station equipment
Connect the REMOTE 1 connectors each other using
the BNC coaxial cables.
4.
Set a personal computer (Setting the F1 to F5 code)
Set the codes of F1 to F5 in accordance with the
following table referring to the document of terminal
emulator.
Key Name
Command
HEX Data
F1
F1
ESC [ 17
~
1B, 5B, 31, 37, 7E
F2
F2
ESC [ 18
~
1B, 5B, 31, 38, 7E
F3
F3
ESC [ 19
~
1B, 5B, 31, 39, 7E
F4
F4
ESC [ 20
~
1B, 5B, 32, 30, 7E
F5
F5
ESC [ 21
~
1B, 5B, 32, 31, 7E
*
ESC = 16 hexadecimal number 1B
10 decimal number 27
5.
Connecting the personal computer to the primary station
In the case of RS-232C :
Use the RS-232C cable and connect the personal
computer to the REMOTE3 connector.
In the case of Ethernet :
Use the dedicated cable and connect the LAN
hub to the NETWORK (DATA) connector.
6.
Setting the communication conditions of the personal
computer
In the case of RS-232C :
Transfer speed : 38.4 kbps, Data bit : 8 bits,
No parity, No check.
In the case of Ethernet :
Set the destination IP address of the terminal
emulator to the same address of the primary
station. Set the port No. to 1001 (default).
