3-1
BKS-R3219A/R1617A I&SSM
3-1. Outline
3-1-1. Flow of Settings
Setting needs to be done in following procedure on the control terminal connected to the primary station
of S-BUS data link before switching the signal.
Section 3
Settings
Initial Setting
Install Equipment
See the Install Manual
for each equipment.
Setup on the primary station
*
Please see the System Setup Manual that came with the routing switcher
for description on setting methods.
Select the type of input terminal name (“type name + number” or description name).
Set the name of source type (VTR, FLM, AUX, etc.). Up to 32 names can be set.
Set the source name (type name and numbers between 001 and 999, such as FLM034).
List of registered source name is called “source table”.
Set the destination name (type name and numbers between 001 and 999, such as
VTR089). List of registered destination name is called “destination table”.
Set the phantom name.
List of registered phantom name is called “phantom table”.
When using type+number selection method, select the destination name that can be set
from this equipment from the destination table, and send it to this equipment. List of this
destination name is called “available destination table”.
(This procedure is not needed when there is no need to limit the destination to be
controlled, or BPS selection method is used.)
It continues to the following page.
