Sony Anycast station AWS-G500, Operating Instructions Manual

Page: 295 / 316

295
Troubleshooting
A
ppen
dix
Audio-related (continued)
The peak indication does not
disappear. The control of the peak
indication is not possible if the
input audio is DV or SDI. Check the input signal. –
DV input
Noise occurs in the video or
audio. No video or audio is
output. The signal is not being received
clearly. Disconnect and then reconnect
the cables. After reconnecting the
cables, restart the connected DV
device and the unit. –
DV output
DV signals are not output. The DV output settings are not
configured. Configure the DV output settings. 191
The aspect ratio is set to 16:9 HD
mode. Set to 4:3 or 16:9 SD mode. 52
SDI output
SDI signals are not output. The aspect ratio is set to 16:9 HD
mode. Set to 4:3 or 16:9 SD mode. 52
Picture-in-picture
The NEXT selection button
flashes and the picture-in-picture
effect is not applied. An attempt was made to use the
same image for picture-in-picture
as the one being used for keying. Select a different image. 87
An attempt was made to use the
image assigned to INT for
picture-in-picture. Select a different image. 87
An attempt was made to use the
same image for picture-in-picture
as the one being used for
program output. Select a different image. 87
Luminance keying, chroma keying, and downstream keying
Keying does not work. Keying is hidden because of the
Crop setting. Change the Crop setting. 109
Keying is hidden because of the
Clip, Gain, or Density settings. Change the values set for Clip,
Gain, or Density. 93, 102
Keying adjustments do not take
effect. A keying source created with
PowerPoint was saved in Tiff
format. Save keying sources created with
PowerPoint in BMP format. 235
Keying does not disappear when
the KEY button is pressed. The KEY button is not an On/Off
button for keying. Make the KEY button light
green, and perform a transition,
such as with the CUT button. 100
Keying does not disappear when
the DSK button is pressed. Luminance or chroma keying is
being performed. Make the KEY button light
green, and perform a transition,
such as with the CUT button. 100
Keying does not disappear when
a transition is performed with the
KEY button lit. Downstream keying is being
performed. Turn off the DSK button. 92
Colors specified with the cursor
are not removed. The correct color cannot be
determined because the cursor
frame is too small. Enlarge the cursor frame. 106
Logos
Keying does not work. Keying is hidden because of the
Clip, Gain, or Density settings. Change the values set for Clip,
Gain, or Density. 98
Problem Possible causes Possible solutions See
page