Sony Anycast station AWS-G500, Operating Instructions Manual

Page: 52 / 316

Ch
apt
er 2 Prep
ar
at
ions
52
Installation/Default Settings
4
Press the MENU button to close the menu.
Selecting the Video Output Signal Format
Select the format for the signals output from the PGM output connectors
(COMPOSITE/S VIDEO), the SD video interface module’s DV connectors, and
the SDI output, HD analog output, HD SDI output, and reference output
connectors on the rear panel.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1
Select [PGM OUT], and confirm;
2
select the signal format, and confirm.
A confirmation message appears.
4
Press the ENTER button.
A shutdown message appears, and the system shuts down.
• Carrying out this selection may cause momentary breakup of the output video.
• When [PAL/50Hz] is selected, small portions of the top and bottom of PAL
input videos will be missing. To avoid this, set the RGB output signal format
to [Video RGB] (page 216).
Video input in a different signal format than this setting can still be displayed
(i.e., displaying a PAL video input when set to “NTSC” or vice versa), but the
video quality cannot be guaranteed.
Setting the PGM Output Aspect Ratio
Select the size (ratio between width and height) of the program output video.
1
Press the MENU button.
2
In the top menu, select [Video Output].
3
1
Select [PGM OUT Aspect], and confirm;
2
select a size for the program
output video, and confirm.
Caution
Note
LCD Backlight
Viewer Priority PGM
File TC Off
1 2
PGM OUT NTSC/60Hz
PGM OUT Aspect 4:3
PGM OUT Level
B NTSC/60Hz
PAL/50Hz
1 2