SNR S2940-8G-v2, Configuration Manual

Page: 88 / 420

SNR S2940-8G-v2 Switch Configuration Guide
DDM Configuration
12.2 DDM Configuration Task List
DDM configuration task list:
1. Show the real-time monitoring information of the transceiver
2. Configure the alarm or warning thresholds of each parameter for the transceiver
3. Configure the state of the transceiver monitoring
(a) Configure the interval of the transceiver monitoring
(b) Configure the enable state of the transceiver monitoring
(c) Show the information of the transceiver monitoring
(d) Clear the information of the transceiver monitoring
1. Show the real-time monitoring information of the transceiver
Command Explanation
User mode, admin mode and global mode
show transceiver [interface eth-
ernet <interface-list>][detail] Show the monitoring of the transceiver.
2. Configure the alarm or warning thresholds of each parameter for the transceiver
Command Explanation
Port mode
transceiver threshold { default | {
temperature | voltage | bias | rx-
power | tx-power } { high-alarm |
low-alarm | high-warn | low-warn
} { <value> | default } } Set the threshold defined by the user.
3. Configure the state of the transceiver monitoring
(a) Configure the interval of the transceiver monitoring
Command Explanation
Global mode
transceiver-monitoring interval
<minutes>
no transceiver-monitoring inter-
val
Set the interval of the transceiver monitor. The no command
sets the interval to be the default interval of 15 minutes.
88