SNR S2940-8G-v2, Configuration Manual

Page: 22 / 420

SNR S2940-8G-v2 Switch Configuration Guide
Switch management
1.2.5 Input Verification
Returned Information: success
All commands entered through keyboards undergo syntax check by the Shell. Nothing will be
returned if the user entered a correct command under corresponding modes and the execution is
successful.
Returned Information: error
Output error message Explanation
Unrecognized command or illegal pa-
rameter! The entered command does not exist, or there is
error in parameter scope, type or format.
Ambiguous command At least two interpretations is possible basing on
the current input.
Invalid command or parameter The command is recognized, but no valid param-
eter record is found.
This command is not exist in current
mode The command is recognized, but this command
can not be used under current mode.
Please configure precursor command
'*' at first! The command is recognized, but the prerequisite
command has not been configured.
syntax error : missing '"' before the
end of command line! Quotation marks are not used in pairs.
1.2.6 Fuzzy Match Support
Switch shell support fuzzy match in searching command and keyword. Shell will recognize com-
mands or keywords correctly if the entered string causes no conflict.
For example:
1. For command show interfaces status ethernet1/1 , typing sh in status ethernet1/1 will
work.
2. However, for command show running-config , the system will report a > Ambiguous com-
mand! error if only show r is entered, as Shell is unable to tell whether it is show run or
show running-config . Therefore, Shell will only recognize the command if sh ru is entered.
22