SNR S2940-8G-v2, Configuration Manual

Page: 318 / 420

SNR S2940-8G-v2 Switch Configuration Guide
802.1x Configuration
dot1x eapor enable
no dot1x eapor enable Enables the EAP relay authentication func-
tion in the switch; the no command sets
EAP local end authentication.
(d) Configure the max user number
Command Explanation
Global Configuration Mode
user-control limit <count> Configure the max controlled/trusted user
number supported by the switch; Without
implementing this command, the default
number would be 128.
3. Supplicant related property configuration
Command Explanation
Global Mode
dot1x max-req <count>
no dot1x max-req Sets the number of EAP request/MD5
frame to be sent before the switch re-initials
authentication on no supplicant response,
the no command restores the default set-
ting.
dot1x re-authentication
no dot1x re-authentication Enables periodical supplicant authentica-
tion; the no command disables this function.
dot1x timeout quiet-period <seconds>
no dot1x timeout quiet-period Sets time to keep silent on port authentica-
tion failure; the no command restores the
default value.
dot1x timeout re-authperiod <seconds>
no dot1x timeout re-authperiod Sets the supplicant re-authentication inter-
val; the no command restores the default
setting.
dot1x timeout tx-period <seconds>
no dot1x timeout tx-period Sets the interval for the supplicant to re-
transmit EAP request/identity frame; the no
command restores the default setting.
dot1x re-authenticate [ interface <interface-
name> ] Enables IEEE 802.1x re-authentication (no
wait timeout requires) for all ports or a spec-
ified port.
318